No. 427 / Tom

[traudi]

Ich vermisse die notwedige Ernsthaftigkeit!

is doch ganz einfach jungs, der spritverbrauch is in etwa gleich

[Harry]

Also jetzt in Farbe ist natürlich alles klar!!

Ich gebs auf! Keine Ahnung!

Ich kaufe ein u

[The_King002]

Belly tank salt lake racer?????????

[marvin]

Guten Morgen, DER ist schon auf Seite 2 zu sehen...und falsch....


...ich kaufe übrigens ein R (wie Rot...)

[mikemuscle]

Die haben das rote dingsbumsteil von diesem dingsbumsflieger original an diesen dingsbumsracer (bild von marvin) eingebaut, weil ................................................
................................................weil sie kein anderes gerade herumliegen hatten? - aehem -

[Kaili]

Dürfte sich um die Ladeklappen (speed break) handeln.

Alternative 1: zum schnelleren Bremsen hat ein Fahrzeug zusätzliche Ladenklappen
(oder kann den Spoiler als Landeklappe verwenden)

Alternative 2: Bei Flugzeug wirken die Landeklappen, damit auch bei voll laufender Turbine der Flieger stehen bleibt (z.B. beim Start, um schneller beschleunigen zu können). Wurde dass bei der Fahrzeugtechnologie auch verwendet, um schneller beschleunigen zu können, oder um in Kurven Tempo zu reduzieren, ohne mit der Drehzahl runterzugehen?

[Gustavltd]

Bein den moderneren NASCAR-fahrzeugen sind Spoiler im Dach verbaut die sich öffnen wenn sich der Wagen umdreht, damit er gebremst wird und nicht aufsteigt.?

Gus

[Tom]

Kaili, Landeklappen bremsen ja nur indirekt, da sie den Auftrieb erhöhen und der Fliega damit langsamer fliegen kann. Aber, ja es geht hier um "Auftrieb / Abtrieb"

Gus, dein Ansatz ist von der Lösung gar nicht weit weg.

Mikemuscle, mmmmmhhhh

@ all
Wer wird denn jetzt, so kurz vorm Ziel aufgeben?
Ausserdem gefällt mir, dass sich mitlerweile hier User beteiligen, die sonst gar nicht in diesen Bereich reinschauen


So, jetzt mach ich es euch aber ganz einfach ...
Kombiniert man den Inhalt meines Flügelbildes mit dem von Marvin geposteten Trans-Am Bild erhält man fast schon die Lösung! So einfach!

[mares]

kann jetzt nur mehr was mit den frontspoilern zu tun haben. die waren in den Bj70-73;74-75;76;77-78 und 79-81 verschieden und haben event. die gleiche auswirkung wie die flächendinger.






mehr weis ich nicht mehr

PS: werde jetzt wahrscheinlich jedes mal beim Landen auf die Dinger schauen und an einem TransAm denken

[Tom]

Mares, nein leider.

Also, wenn ihr schon beim Buchstaben kaufen seid ...

_ur_e_ - _ _ _ _

[sim]

ein s

[Toaschtn]

Unser Tom .........




.............

Ich möchte gern ein N kaufen

[Tom]

Cool, ich bin der Glücksradmann

Nix is jetzt, strengt euch an und löst!

[Driver]

Cool, ich bin der Glücksradmann

Nix is jetzt, strengt euch an und löst!

doch nicht der porno peter?:





das rätsel ist gemein

[marvin]

THE GURNEY FLAP!

Few people, even the greats of motorsport, get to have their moniker attached to something they invented. Colin Chapman, perhaps the greatest innovator of them all, had only the Chapman strut named after him, and that was hardly his finest creation. For a driver-turned-team owner to enjoy the privilege is virtually unknown. There's no Brabham caliper or Surtees inlet, for instance, or Prost linkage come to that. But there is a Gurney Flap, named after Dan Gurney - a device, moreover, which has retained its currency in a way that Chapman's minimalist rear suspension never did.

If you understand anything of aerodynamics you'll know what a flap is: a (generally) hinged device at the trailing edge of a wing which can be lowered to increase lift when an aircraft is taking off or landing. The prolonged whirring you often hear a few minutes before a commercial airliner touches down is the flaps being deployed: large, hydraulically-actuated auxiliary surfaces which sprout from the rear of the wing and curl down like a crooked finger.

A Gurney Flap – often called simply a Gurney or a wickerbill in the US – is nothing like as sophisticated. Classically it's no more complex than a length of aluminum right-angle rigidly bolted or riveted to a wing's trailing edge. Usually it's a wing intended to keep a racing car on the road, although the Gurney Flap does also see some aircraft service, on helicopter tailplanes for example. Crude as it looks, it serves essentially the same purpose as the complex flap on an aircraft wing it increases lift or, in this instance, downforce.

Conception of the Flap was, to use Dan Gurney's own description, a classic example of necessity being the mother of invention. It happened in 1971 while his AAR team was testing its new USAC car at Phoenix, prior to the season's first race there. The car was too slow and everyone knew it. Towards the end of the third and last day of testing, driver Bobby Unser challenged 'the boss' to come up with a solution, and Gurney suggested the flap. He'd seen the success Richie Ginther had had experimenting with spoilers on Ferrari sportscars and wondered what would happen if a small spoiler was fitted along a wing's trailing edge.

In 45 minutes or so, the first Gurney Flap was fabricated and attached to the car's rear wing, and Unser went out again. Within a couple of laps it was clear he was circulating no faster than before and everyone in the pit assumed the flap was a failure. But when Unser came in he called Gurney over and quietly asked him whether anyone was around to spy on what they were doing. Once Gurney had confirmed they were alone, Unser told him the rear was now so well planted that the car was pushing (understeering) badly, hence the poor lap times. All they needed to do was restore the aerodynamic balance by adding more front-end downforce and the car would be transformed.

For most of that first season, none of the other teams cottoned on to what Gurney had achieved. Anyone who asked was told that the flap was a purely structural feature to strengthen the wing's trailing edge. Taken in by this, some teams tried fitting Gurneys on the underside of the wing with predictable results: they lost lap time or worse. Eventually word got around that the Flap was an Eagle secret weapon and everybody started using it, whether they understood its function or not. As Carroll Smith bluntly observed in Tune To Win, "It was a case of monkey see monkey do".

Gurney, meanwhile, had allowed McDonnell Douglas in on the secret and was given access to an old wind tunnel in which to test it. Measurements on the test wing showed that fitting the Gurney Flap affected pressure across the wing's entire upper and lower surface, increasing lift (or downforce) and reducing flow separation on the wing's suction side. Gurney placed the patenting of the device in the hands of McDonnell Douglas and, for some years after, AAR cars used to carry 'Pat Pend' scripts on their wings.

This patenting effort, however, eventually came to nothing, not least because one Edward F Zaparka had patented a similar device as far back as the early 1930s. As Dan wryly pointed out when he faxed me a copy of Zaparka's patent, it was originally filed on 3 April 1931 – exactly 10 days before one Daniel Sexton Gurney was born.

Dr Bob Liebeck, the McDonnell Douglas aerodynamicist hired by AAR as a consultant to help design its cars in the 1970s, was the first to hypothesize that the Gurney Flap's effect was the result of small twin vortices generated immediately downstream of its lip. Various studies conducted since have confirmed this, the most recent being by researchers at both Southampton and Glasgow universities. Sponsored by Penske Cars, this used a technique called laser Doppler anemometry (LDA) to measure the direction and speed of airflow across a tightly-packed grid of points downstream of the Gurney.

Thirty years on from its first, mysterious appearance, the Gurney Flap is still widely utilized in motorsport as an inexpensive and effective aerodynamic tweak. Fitting or removing a Gurney, or changing its height, are quick, straightforward-to-do and repeatable ways of tuning a car's set-up.

Insignificant as it looks, this deceptively simple device has helped win countless races over the years – which must make it a very gratifying thing to carry your name.